Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Kennedale
Gate access control in Kennedale typically runs $450-$2,800 depending on whether you’re adding a keypad to an existing operator, installing a phone entry system, or running conduit for a full video intercom on a long rural driveway. Most repairs and retrofits are completed in one visit. We dispatch to Kennedale daily, and a live person answers the phone 24 hours a day at (817) 286-7391. Ironworks Gate Co. has been doing this work for over 42 years, and we know what Kennedale’s clay soil and acreage lots do to gate electronics.
Key Takeaways:
- Keypad entry systems in Kennedale typically run $550-$1,800 installed, depending on wiring distance.
- Solar-powered operators on rural lots lose battery capacity through North Texas winters, often failing by February.
- Clay heave from Tarrant County Blackland Prairie shifts gate posts, tripping safety photocells and causing false reverses.
- Most access control repairs are completed same visit. Free estimates before any work starts.
Why Ironworks Gate Co. Is Kennedale’s Preferred Gate Access Control Company
We’re a gate specialist, not a general handyman. That distinction matters here. A Kennedale acreage gate with a solar operator and a welded pipe frame is not the same animal as an ornamental suburban driveway gate in Mansfield. Our techs are trained on nine gate automation brands including FAAC, BFT, and Linear, so we carry the right parts on the truck for whatever is on your driveway.
Most of our Kennedale customers found us after another contractor couldn’t fix a gate that drifted out of plumb or kept reversing on its own. The common thread is clay soil. We know to check post alignment before we touch the electronics, because a gate that’s half an inch out at the hinge will never close cleanly no matter how good the operator is.
Victor Salinas founded this company in 1984, and our 90-Day Done Right Promise applies to every access control job we complete in Kennedale. Written, no arguing, no fine print. If it is not right, we come back and make it right. That’s the Keystone Standard.
Our Gate Access Control Services in Kennedale
Keypad Entry
Adding or replacing a keypad entry system in Kennedale usually runs $550-$1,800. Most of our acreage installations use weather-sealed keypads mounted on a treated post or mast arm near the gate, wired back to the operator with direct burial cable. On clay-heavy lots, we set the keypad post deeper than the frost line and backfill with compacted select fill so it doesn’t lean out of level by the next wet spring.
Remote Control
Remote controls for Kennedale gate operators are the most straightforward job we do, and most run $85-$250 when we’re programming or replacing transmitters. If your builder-grade operator only came with one remote and you’ve had to share it for a decade, we can program additional remotes on most LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule systems. A live person answers the phone 24 hours a day, so call us at (817) 286-7391 and we’ll tell you exactly what’s possible before you spend a dime.
Phone Entry
Phone entry systems for a Kennedale home with a long gravel driveway typically run $800-$2,200. These are ideal when you want to answer the gate from inside the house without running back and forth. We install the call box at the gate, then program it to ring your landline or cell. On rural lots without power at the gate, we pair these with solar charging and a battery bank sized for North Texas’s cloudy winter stretches, not just the sunny summer.
Card Reader
Card readers make sense for Kennedale properties with multiple vehicles, horse trailers, or regular deliveries. A typical card reader installation runs $600-$1,400, including programming of the first set of credentials. These are popular with families on multi-acre lots off Kennedale-New Hope Road and Dick Price Road who want their ranch hands or adult children to have separate access codes they can revoke individually.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Kennedale
We stock parts locally for FAAC, BFT, and Linear systems, along with six other majors. That means when a Kennedale customer calls us about a Viking operator that won’t respond to the remote, we don’t have to order a board and wait a week. We carry the common failure components on the truck: control boards, transformers, receivers, photocells, and solar regulators. If you’ve inherited a gate system with the house and you’re not sure what brand it is, call us at (817) 286-7391 and describe the operator. We can usually identify it from the housing, then bring the right parts on the first visit.
Common Gate Access Control Problems We See in Kennedale Homes
- Solar batteries failing in winter. Kennedale’s rural entrances often rely on solar-powered operators because trenching power 300 feet down a gravel drive is expensive. But November through February, overcast skies drain the battery bank. A gate will then work fine at noon and fail completely by evening. We replace the battery and charging regulator, then verify capacity before we leave.
- Clay heave shifting gate posts. Tarrant County Blackland Prairie clay expands when wet and shrinks when dry. Over one season, a gate post can move enough that the gate binds, the photocell sees a false obstruction, and the operator refuses to close. This is the single most common access control failure we see on Kennedale acreage. The fix is resetting the post footing, not just adjusting the operator limits.
- Builder-grade operators with no conduit from house to gate. Many newer subdivision homes in Kennedale came with a gate operator but no spare conduit. Adding a keypad or video intercom later means trenching through dry, hard clay or rigging solar power where sunlight is poor near a wood line. We handle both, and we’ll give you a straight quote before any trenching starts.
- Rack and pinion slide gates jamming on dirt and gravel. Long rural drives mean slide gates, and slide gates mean rack teeth that catch silt and gravel from unpaved approaches. A packed rack strips the operator’s drive gear, the gate stops halfway, and the access control system looks dead. We clean the rack, replace the gear, and add a brush guard so it doesn’t happen again next month.
Pricing for Gate Access Control in Kennedale, TX
Here are honest numbers for what access control work costs in Kennedale. Keypad entry: $550-$1,800. Remote control programming or replacement: $85-$250. Phone entry system: $800-$2,200. Card reader: $600-$1,400. Video intercom: $1,200-$2,800, higher if we’re trenching conduit through dry clay to a gate without power. Solar gate opener repair or battery replacement: $250-$650 depending on the battery bank and regulator.
What moves the price is access. A gate sitting off a paved circular drive near the house is quick work. A welded pipe gate 400 feet down a gravel lane with no power needs solar, trenching, drainage consideration, and a technician who understands ranch gates and automation together. The price is quoted and agreed before any work starts. No surprises on the bill. That’s a square deal, and it’s how we do every job in Kennedale.
We Also Serve Cities Near Kennedale
Ironworks Gate Co. provides Gate Access Control throughout the southern edge of the Metroplex. If you live in Arlington, Mansfield, Fort Worth, or Burleson, the same crew that serves Kennedale can reach you fast. Dispatch and scheduling are coordinated from our Dallas-Fort Worth office, and we’re in this part of Tarrant County regularly.
Serving Kennedale, TX - Our Local Coverage Area
We’re based in the Kennedale area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Kennedale
The cause is almost always Blackland Prairie clay heave pushing one gate post a fraction of an inch out of plumb. When the clay dries and shrinks in summer, the post settles slightly and the gate loses its alignment, so the latch no longer catches or the photocell sees a false obstruction. We fix it by resetting the post footing into stable soil and re-hanging the gate, not by adjusting the operator settings to compensate. Call (817) 286-7391 and we’ll come check the alignment before the gap gets worse.
Yes. We add keypads to solar-powered operators on Kennedale acreage properties regularly. The keypad gets its own small solar panel and backup battery so it works independently of the main gate operator. We size the battery for a run of cloudy days, not just a sunny afternoon, because we know what November through February does to solar systems out here. Installed cost typically runs $650-$1,500 depending on wiring distance and whether we need a new mast arm.
The most likely cause is water intrusion at the conduit or photocell wiring combined with clay swelling that shifted the gate post. A soaked junction box on a builder-grade install without proper drainage will short the photocell circuit, and the operator then refuses to close because it thinks something is blocking the gate. We trace the wiring, replace whatever the water ruined, and seal the enclosure properly. If the post shifted, we address that too. Call (817) 286-7391 for a free estimate on the diagnostic.
For a long gravel driveway on a Kennedale acreage lot, a video intercom usually earns its cost. You’ll want to see who’s at the gate before opening it, especially if you can’t see the entrance from the house. A phone entry system lets you talk, but a video intercom lets you reject someone without walking out. Video intercoms run $1,200-$2,800 installed here. If your budget is tighter, start with phone entry and add a camera later. We’ll give you an honest recommendation for your specific driveway layout.
That February storm seized the operator’s drive train and the control board interpreted the resistance as an obstruction. Ice also cracked several plastic control board housings on exposed rural driveways around Kennedale. The fix was not a new operator in most cases. It was a heated enclosure or a weatherproof cabinet relocation, plus new limit settings for the gear train. If your gate still hesitates on cold mornings, call (817) 286-7391. That’s the kind of failure we’ve seen enough times in Kennedale to fix on the first visit.
Contact Ironworks Gate Co. in Kennedale
If your gate access control system is acting up or you want to add keypad entry, phone entry, or a video intercom, call us at (817) 286-7391. A live person answers, every time, day or night. We’ll quote the job before any work starts, and every completed job carries our 90-Day Done Right Promise in writing. Victor Salinas and the Ironworks Gate Co. crew have been doing this work for over four decades. We’ll be there when we say.
Written by Victor Salinas, Owner at Ironworks Gate Co., serving Kennedale since our founding in 1984.