Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Haltom City
Gate access control in Haltom City means keypads, remotes, phone entry, card readers, and video intercoms installed on gates that are usually 50 to 70 years old and fighting Tarrant County clay. We know those gates. We know the soil under them. If you live east of Haltom Road or out around Fossil Creek, you’ve watched your chain-link gate drag on one side and gap at the latch on the other. That’s not a hinge problem. That’s the ground moving under your post. Ironworks Gate Co. fixes the real problem and wires the access system to hold through the next wet-dry cycle. Call (817) 286-7391 for a free estimate, and a live person answers.
Why Ironworks Gate Co. Is Haltom City’s Preferred Gate Access Control Company
We’ve worked enough Haltom City driveways to know what we’re walking into before we open the truck. Most homes here were built between the 1950s and 1970s, fenced with galvanized chain-link at original construction. Those posts were set in expansive black clay. Every spring the clay swells. Every August it shrinks. After fifty or sixty of those cycles, the posts don’t sit plumb anymore. A gate access system bolted to a racked frame will misalign sensors, strain the opener, and fail early. So we start with the post, then we install the electronics. That order of operations is why Haltom City homeowners call us back and why they tell their neighbors.
Victor Salinas leads our access control work, and the standard he sets is the same on every job: the weld is right, the wire is landed correctly, the safety loop is tested, and the guarantee is written. We’re not the cheapest bid in Haltom City and we won’t pretend to be. We’re the company that fixes it once. We carry a 90-Day Done Right Promise in writing on every job. If it isn’t right, we come back and make it right. No paperwork, no arguing. That’s the Keystone Standard, and it applies to a $200 keypad repair the same as a full video intercom install.
Our crews carry parts for LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Most Haltom City jobs finish in a single visit. You get the price before a single bolt turns. And a live person answers 24 hours a day, seven days a week, so if your gate opener dies at 6 a.m. on a Tuesday, you’re not leaving a voicemail and hoping.
Our Gate Access Control Services in Haltom City
Keypad Entry
The most common access upgrade for Haltom City’s aging chain-link gates. We install weather-sealed keypads rated for North Texas sun and ice, wired or wireless, on new posts or existing ones that we’ve first straightened and re-collared. A keypad frees you from handing out keys or leaving the gate propped open for the lawn crew. In Haltom City, most keypad entry jobs run $450 to $950 installed, depending on whether we’re pulling a new post or wiring to an existing opener.
Remote Control
We program and replace remotes for all nine brands we service, including FAAC, BFT, and Linear. If your remote worked last year and quit after a storm, the board may be fine and the receiver antenna may have gotten knocked out of alignment when the gate frame shifted. We diagnose that before selling you new hardware. A replacement remote or receiver in Haltom City typically costs $120 to $350, parts and programming.
Phone Entry
For Haltom City homeowners who want delivery drivers, caregivers, or family to reach the gate without an app. A phone entry system ties the gate to your landline or cell, and you grant access with one button. For older brick-veneer ranch homes with existing telecom runs, the install is straightforward. A phone entry system with a wired keypad and controller in Haltom City runs $800 to $1,400 typically.
Card Reader
Some Haltom City properties, especially those with rental units or workshop access off the alley, use card readers so each person has a credential that can be revoked individually. We install proximity readers, key fobs, and the controller hardware. Expect to pay $600 to $1,200 for a single-card-reader setup, depending on whether it ties into an existing opener or requires a new control board.
Video Intercom
More Haltom City homeowners are adding video intercoms to their driveway gates, especially on corner lots along Denton Highway and streets off Belknap where foot traffic is heavier. A video intercom lets you see and speak to whoever is at the gate before you open it, from a handset inside or your phone. A full video intercom with a camera-equipped call station and monitor runs $1,200 to $2,800 in Haltom City, depending on door station type and wiring distance.
Smart Access
Smart access means your gate talks to your phone. You can open it from the grocery store parking lot, check the log of who entered, and get alerts when the gate cycles. We retrofit smart controllers onto existing openers from LiftMaster, Viking, and others, or install them as part of a new automation package. A smart access retrofit in Haltom City typically runs $500 to $1,100. If we’re trenching new low-voltage wire from the house to the gate, that adds to the price.
Every access control job starts with the gate itself. If the post is heaved, the frame racked, or the hinges corroded, no electronics will hold adjustment. We fix the steel first. Then we make it smart. For the full scope of what we do, see our Gate Access Control service page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Haltom City
We’re trained and equipped on nine gate-automation brands, including FAAC, BFT, and Linear, and we carry common boards, remotes, receivers, and safety sensors in our trucks so Haltom City jobs finish in one visit. If we need a part we don’t have, we get it from our Dallas-Fort Worth supply channels and we’re back on your driveway fast. We don’t push one brand. We fix the one on your gate.
Common Gate Access Control Problems We See in Haltom City Homes
- Heaved hinge posts pulling gates out of square. Tarrant County black clay expands after spring rain and shrinks in summer drought, lifting posts two to four inches above grade over decades. The gate drags on one side, gaps at the latch, and the access control sensors fight a frame that’s no longer square.
- Corroded hinge straps and bent top rails from patch repairs. Many Haltom City gates have been repaired four or five times by different hands. We find hinge straps so corroded they snap when we try to adjust them, and bent rails that make a clean latch alignment impossible until we straighten or replace the rail.
- Operators that died after a freeze event. Winter Storm Uri in 2021 bent lightweight chain-link tops and misaligned entrapment sensors on dozens of older openers we’ve since replaced across the 76117 area. If your operator has never been the same since that ice, the board may be fine but the mechanical alignment isn’t.
- Keypads and intercoms mounted to shifting posts. We regularly see keypads that worked fine for years until the post underneath them moved. The electronics are fine. The mount isn’t. Re-setting the post fixes the keypad angle, the gate swing, and the sensor alignment in one job.
Pricing for Gate Access Control in Haltom City, TX
You should know what this costs before you pick up the phone. For Haltom City, a keypad entry system runs $450 to $950 installed. Remote replacements or receiver repairs land at $120 to $350. Phone entry systems are $800 to $1,400. A single card reader setup runs $600 to $1,200. Video intercoms are $1,200 to $2,800 depending on the door station and wiring run. Smart access retrofits on an existing opener run $500 to $1,100. If your gate post needs re-setting before any of that, add $250 to $450 for a concrete collar and frame realignment. That soil work is often the difference between an access system that lasts two years and one that lasts twenty. Every price is quoted and agreed before any work starts. No surprises on the bill. We offer a free estimate, a free second opinion on any written estimate, $50 off any repair over $250, an $89 seasonal tune-up, and a 5% senior and veteran discount, always.
We Also Serve Cities Near Haltom City
Our crews serve Haltom City, plus Fort Worth, Hurst, Bedford, and Kennedale. If you’re on the Haltom City side of the line, you’re in our regular service area and we treat your street like it’s our own. For a look at the full city service area, see Gate Access Control in Haltom City.
Serving Haltom City, TX - Our Local Coverage Area
We’re based in the Haltom City area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Haltom City
Because the hinge post has heaved out of the ground. Tarrant County’s expansive black clay swells when wet and shrinks when dry, and after 50 or 60 years of that cycle, the post lifts two to four inches above grade. When the hinge side rises, the gate tilts down toward the latch, so it drags the ground near the hinge and gaps wide at the latch. The fix is to dig out the post, re-set it with a concrete collar, and re-hang the gate square. Bending the hinge or shimming the latch is a temporary patch that fails again when the soil moves. Call (817) 286-7391 and we’ll confirm whether the post is the problem before quoting the work.
Most of the time, yes, your existing gate can support a keypad as long as the frame is straight and the post is stable. We inspect the post, hinges, and rail first. If the frame is racked, we re-set the post and straighten the frame, then mount the keypad and operator. If the frame is so corroded that welding repairs won’t hold, we’ll tell you that plainly and show you what a replacement gate costs. You keep the decision. Call (817) 286-7391 for a free on-site look at your specific gate.
Yes, we see it across the 76117 area. Ice events like Winter Storm Uri bend lightweight chain-link tops and twist frames just enough to throw the entrapment sensors out of alignment, and many older operators never recovered. Sometimes the board is fine and the fix is mechanical: straighten the top rail, re-align the sensors, re-set the limits. We’ll diagnose it before we sell you an opener. Call (817) 286-7391 and describe what you’re seeing; we’ll give you an honest read.
Usually yes. A manual gate operated by hand tolerates a leaning post. An automatic opener applies steady torque every cycle and will shake a loose post loose in a season. We re-set the hinge post with a concrete collar, often wider and deeper than the original 1960s pour, before mounting an opener. On Haltom City clay, that footing work is what makes the opener last. We’ll include it in the written estimate, so you see the full price upfront.
Stand at the closing edge of your gate and have someone cycle it. The gate should reverse immediately on contact, or stop dead if it detects pressure. If it keeps pushing, the entrapment protection has failed. That’s a safety problem and a code problem. We test entrapment sensors on every single access control and opener job in Haltom City, and we’ll test yours for free when we’re out for any repair. Call (817) 286-7391 and we’ll schedule it.
Written by Victor Salinas, Owner at Ironworks Gate Co., serving Haltom City and the surrounding Tarrant County communities.